Welcome to the official website of Shenzhen JinXiong Electronic,Co.,Ltd

Tel:0086-755-29792835
Email:sales@kxpcba.com

Home  >  PCB Fab  >  FAQs
PCB Fab

PCB Capacity

Multilayer PCB

Flexible PCB

Rigid Flex PCB

Metal Core PCB

Ceramic PCB

HDI PCB

Rogers PCB

Heavy Copper PCB

Main Equipments

FAQs

Assembly

PCB Assembly Prototype

PCB Assembly Services

Low-Volume PCB Assembly

Turkey PCB Assembly

SMT Stencil

Product Package

Main Equipments

FAQs

Other Service

PCB Layout

PCBA reverse

IC Decipher

What are the requirements for the spacing of printed circuit board wires?

Time:2020-11-24 Preview:139

What are the requirements for the spacing of the conductors on the printed circuit board? Honglian believes that the spacing between adjacent conductors must meet electrical safety requirements, and in order to facilitate operation and production, the spacing should be as wide as possible. The smallest

The spacing must be at least suitable for the voltage tolerated. This voltage generally includes I working voltage, additional fluctuating voltage, and peak voltage caused by other reasons. If the relevant technical conditions allow a certain degree of metal residues between the wires, the spacing will be reduced. Therefore, the designer should take this factor into consideration when considering voltage. When the wiring density is low, the spacing of the signal lines can be increased appropriately, and the signal lines with high and low levels should be as short as possible and increase the spacing.

The minimum width of the conductor of the printed circuit board is mainly determined by the adhesion strength between the conductor and the insulating substrate and the current value flowing through them. When the thickness of the copper foil is 0.05mm and the width is 1-1.5mm. With a current of 2A, the temperature will not be higher than 3°C, and a wire width of 1.5mm can meet the requirements. For integrated circuits, especially digital circuits, 0.02-0.3mm wire width is usually selected. Of course, as long as possible, use as wide a line as possible. Especially for power lines and ground lines, the minimum spacing of wires is mainly determined by the insulation resistance and breakdown voltage between the wires in the worst case. For integrated circuits, especially digital circuits, as long as the process allows, the spacing of the wires can be as small as 5-8mm.

But for large currents, if the current load is calculated as 20A/mm2, when the thickness of the copper clad foil is 0.5MM, (generally so much), the current load of the 1MM (about 40MIL) line width is 1A.

Therefore, the line width of 1 -2.54MM (40-100MIL) can meet the general application requirements. The ground line and power supply on the high-power equipment board can be appropriately increased according to the power level, and in the low-power digital circuit

Above, in order to improve the wiring density, the minimum line width is 0.254-1.27MM (10-15MIL) to meet.

There are both high-voltage circuits and low-voltage circuits on the printed circuit board. The components of the high-voltage circuit part and the low-voltage part should be placed separately. The isolation distance is related to the withstand voltage to be withstand.

At 2000V, the distance between the board should be 20mm, and above this, it will be increased in proportion. For example, if you want to withstand the 3000V withstand voltage test, the distance between the high and low voltage lines should be more than 35mm. In many cases, to avoid creepage , Also slotted between the high and low voltage on the printed circuit board. The circuit boards we made also have high and low voltage circuits, and the circuit spacing between the high and low voltages is 10mm.